How are my numbers 460hp and 410tq @30psi on E85 DYNO PACK
EVO IX_STOCK BLOCK
MODS ARE,,
FP RED
INJEN UICP/ INJEN INTAKE
HKS OPEN FILTER
LICP 2.5
STOCK O2/STOCK MAINFOLD
STOCK TB/STOCK INTAKE MANIFOLD
2.75 DP/3" TEST PIPE/EXHAUST
HKS 272
1000cc
WALBRO 255
MBC
EBAY INTERCOOLER

 

Get ready for your thread being closed!! Requires a dyno sheet! Oh and nice power!

 

Good power, but yea need dyno sheet

 

My bad dyno sheet coming soon,,

 

looks tow low for me fp red on pump gas make 450 hp

 

That pretty much means nothing. What kinda dyno, what mods, who tuned it, what were the weather and conditions like, what boost, etc. The OP's tune was probably a little more conservative and/or safer than yours.

 

Good #'s considering the intercooler, intake & 2.75" downpipe used! Congrats dude.

 

He said dynapak....aka the highest reading dyno available most ofthe time. Take your car to a mustang or dyno dynamics dyno. I suspect the numbers will be significantly lower.

 

Not to start another dyno war, I was tuned @ 333whp on a Dynapack back in 2005 with no CF then made a pull at Drift Office and layed down 335whp uncorrected same month. Boost could have been higher or lower though, idk but mods/tune were same. Not saying it means much, just saying the #'s aren't going to be that much different. He should just visit a Dynojet, that's what everyone compares their #'s to anyway

 

FP RED
INJEN UICP/ INJEN INTAKE
HKS OPEN FILTER
LICP 2.5
STOCK O2/STOCK MAINFOLD
STOCK TB/STOCK INTAKE MANIFOLD
2.75 DP/3" TEST PIPE/EXHAUST
HKS 272
1000cc
WALBRO 255
MBC
EBAY INTERCOOLER

The parts in bold need to be changed and you can expect a nice jump in power.

 

Dyno's are tuning tools. If he was tuned at RRE with their Dynapak it reads similar to other dyno's in the area, actually lower in what Ive personally seen.

 

not bad for numbers considering u can get alot more w/ better parts

 

this seems to be right in the neighborhood of what a pump gas setup would do, so seems the mods that were highlighted are holding back the car, and with the better gas and once the parts are changed there is a ton of room for 500whp stock block!

 

Which comp housing does this Red have? Also, upgrade the intake kit to a Perrin or some such and port the exhaust manifold as well.