Notices
Evo Engine / Turbo / Drivetrain Everything from engine management to the best clutch and flywheel.

Cams w/ no tune runs lean?

Thread Tools
 
Search this Thread
 
Old Aug 24, 2007 | 03:50 PM
  #1  
PurEvo's Avatar
Thread Starter
Evolving Member
iTrader: (2)
 
Joined: Feb 2006
Posts: 255
Likes: 1
From: Mississippi
Cams w/ no tune runs lean?

Cams with no tune makes the car run lean right? I dont have a tune yet but it's coming soon. I decided to give the car some gas and see what the air/fuel gauge says. I lowered the boost to bout 1.3-1.4 bar. At WOT, my AEM uego says average 10.9. Will be car be Ok until I get tuned??
Reply
Old Aug 24, 2007 | 03:56 PM
  #2  
kreionic's Avatar
Evolved Member
iTrader: (14)
 
Joined: Apr 2006
Posts: 2,258
Likes: 0
From: MD/ NY
With the S1 in my car I went about .5 rich. Did you say your running 10.9 with cams and no tune? If so you richened up aswell
Reply
Old Aug 24, 2007 | 03:59 PM
  #3  
PurEvo's Avatar
Thread Starter
Evolving Member
iTrader: (2)
 
Joined: Feb 2006
Posts: 255
Likes: 1
From: Mississippi
Well, I have dynoflash from before. Is it Ok to floor my car? or I still have to babie it until I get a custom tune? I'm running the gsc s1's also.
Reply
Old Aug 24, 2007 | 04:04 PM
  #4  
SpeedJunkyz's Avatar
Evolved Member
iTrader: (16)
 
Joined: Jun 2007
Posts: 757
Likes: 0
From: York, PA..... GSX Bound
just babie it to be safe.....You might damage something else in the mean time and then hunting that down is harder. How far away is this tune?
Reply
Old Aug 24, 2007 | 04:39 PM
  #5  
PurEvo's Avatar
Thread Starter
Evolving Member
iTrader: (2)
 
Joined: Feb 2006
Posts: 255
Likes: 1
From: Mississippi
hopefully this month. There's a post on Al's tuning trip to new orleans, but Nobody is getting a certain date set. I'm voting for asap but who knows. =/
Reply
Old Aug 24, 2007 | 05:05 PM
  #6  
Dead-Man Inc's Avatar
Evolved Member
 
Joined: Sep 2004
Posts: 870
Likes: 0
From: Bahrain
if no body is sure than just go for Mellontuning

cheap and one of the Best !
Reply
Old Aug 25, 2007 | 06:58 AM
  #7  
PurEvo's Avatar
Thread Starter
Evolving Member
iTrader: (2)
 
Joined: Feb 2006
Posts: 255
Likes: 1
From: Mississippi
Where's the closest place to go for tuning? I live in south mississippi and the closest good place to go is top speed in atlanta. Where's mellontuning at?
Reply
Old Aug 25, 2007 | 07:11 AM
  #8  
joedr's Avatar
EvoM Moderator
iTrader: (27)
 
Joined: Feb 2006
Posts: 792
Likes: 2
From: Puerto Rico
I went from 11.3 AFR @ 25 PSI peak to 10.7 AFR @21 PSI peak. Just by swapping the cams. No other changes!

After bringing the MBC to ~25 PSI peak, the AFR went to ~11.0. On the tuning side, the peak load cells were landing differently and had to do some fine tuning to get it close enough to 0-3 knocks and 11.2-11.3 AFR.
Reply
Old Aug 27, 2007 | 01:05 AM
  #9  
frost318's Avatar
Evolving Member
iTrader: (15)
 
Joined: Nov 2005
Posts: 166
Likes: 0
From: Louisiana
I would get that tuned ASAP. purevo werent u one of the people going to the tune in New orleans? What ever happened with that?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
EvoJutsu
Evo X General
9
Oct 21, 2009 04:33 PM
velasco581
ECU Flash
19
Sep 2, 2008 05:00 PM
S1monLM
Evo Engine / Turbo / Drivetrain
8
Jul 15, 2006 08:47 AM
Hatorade
Evo Engine / Turbo / Drivetrain
7
Jul 21, 2005 04:00 PM




All times are GMT -7. The time now is 06:57 AM.