Question: I have both my electronic boost gauge sensor and EBC tee'ed off my fuel pressure regulator vacuum line. Is this OK? I know it is common pratice to tee off this line for the boost gauge but is it OK to attach the EBC too? If not, then any suggestions for another vacuum source?

 

I have mine T'd off the wga line near the intake manifold.

The way you have it will work but I wouldnt recommend it in case of boost leak occurs on the line etc....

 

That's where the Stock Factory MR's are tied in to. Put some small zip ties on all the ends, really tight.

 

I was kinda wondering the same thing, where is the BEST place to T for a boost gauge?

 

there is an egr vac line right next to the FPR line that is a much better/safer place to T into for a boost gauge