Mirage VR-X JDM Spec
I never had the car dynoed (185-200whp est.). Only street tuned. Never ran at a track either (13.7-14.2@100ishmph est.). Runs good though. Some minor bucking at part boost, and a big time oil leak from the oil drain line. Runs good enough to pull from stock Evos from a roll
It used to handle AMAZING whn it was NA. Espeically for being FWD. But now with boost and an open fron diff. all the handleing characteristics have gone done the drain.


T-2small (t25)



/threadjack
It used to handle AMAZING whn it was NA. Espeically for being FWD. But now with boost and an open fron diff. all the handleing characteristics have gone done the drain.

T-2small (t25)



/threadjack
Hey MitsuJDM,
Amazing man, i actually looked at most of your pics on Flickr when i saw the link in your sig. Very cool Mirage, pics are real clean too. Looks like u need a better Diff
Amazing man, i actually looked at most of your pics on Flickr when i saw the link in your sig. Very cool Mirage, pics are real clean too. Looks like u need a better Diff
The 7 and 8 MAF are the same. It won't run rich if you use a 7/8 ecu with the MAF and injectors. You will have to reflash to remove error codes, whch can be done during tuning.
I never had the car dynoed (185-200whp est.). Only street tuned. Never ran at a track either (13.7-14.2@100ishmph est.). Runs good though. Some minor bucking at part boost, and a big time oil leak from the oil drain line. Runs good enough to pull from stock Evos from a roll
It used to handle AMAZING whn it was NA. Espeically for being FWD. But now with boost and an open fron diff. all the handleing characteristics have gone done the drain.


T-2small (t25)



/threadjack
It used to handle AMAZING whn it was NA. Espeically for being FWD. But now with boost and an open fron diff. all the handleing characteristics have gone done the drain.

T-2small (t25)



/threadjack

Last edited by wreckleford; Jun 16, 2008 at 11:10 AM.
I know the Evo Diagrams are somewhere on this site.
Any idea where I can get an ECU pinout diagram for a CM5A GSR like mine? So I can compare.
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post




