nice.... I got my 2 quart unit in there this weekend too... workin real good!

out of curiousity... how much air psi u put in it?

 

I tested with 60 psi for leaks, then dropped the pressure to 10 psi and started the car.

 

only 10 psi?

im runnin it with 40psi

 

That's right out of the instructions. They say to have it at 5-10 psi when you first start the car to fill it up. At idle - full it reads about 90 psi.

 

yea... mine is at about 90psi full...

 

thanks for this info guys. exactly what i was looking for as i'm about to install mine this weekend.

btw this port is actually 3/8 BSP (british standard pipe) but they are so close pitchwise it should seal ok.

http://www.pegasusautoracing.com/thr...ting-guide.asp

 

oh yeah, how long of a run is it to make it back to the trunk. want to make sure i order enough line.
i'm thinking 20" should cover it fine, yes?

 

20 feet will do it for sure. I can't remember the exact length but I bought stuff too short on the first try!

 

Are you guys confident that the two ports in the oil filter housing are interchangable?

FP's oil feed line (from the filter) instructions state that one of the ports is for pre-filter "dirty" oil, and the other is post-filter "clean" oil.

http://store.forcedperformance.net/m...vo_Oil_Install

Are they right or wrong?

 

I'm not totally sure....

But when I pulled the rear plug it looked like it was a machining access point for creating an "L" shaped passage, and it looked like it went to the other port.

Nils might know for sure....

 

nice installation,
would it affect pressure that the hose is too long?

 

hey guy i need some help ! i have my oil pressure gauge line running straight from one of the empty plugs on the oil filter housing and it keeps breaking off !! is there a better place to hook that sensor to or do you guys know what i should use to hook it because obviously the brass fitting i installed from auto zone isn't working!!

 

hey guy i need some help ! i have my oil pressure gauge line running straight from one of the empty plugs on the oil filter housing and it keeps breaking off !! is there a better place to hook that sensor to or do you guys know what i should use to hook it because obviously the brass fitting i installed from auto zone isn't working!!