Talking about the round retainer clip attached to the pressure plate the TOB goes through. I was curious if these are available through the dealer without having to buy a new pressure plate? Tried to find a part number but no luck. Will call the dealer tomorrow but was curious if anyone knew. For what its worth I have an Exedy twin disk but I think the snap rings are the same. Looks like I have two outer retainer fingers missing on mine.

 

I already passed on this info to you.

 

Ya I did also, read your PM's.....I didn't actually but just busting your *****.

 

I posted this at the same time I did on the colorado board. Thanks! STM has them along with No Limit Motorsport. I ordered it from No Limit since they already had my info from the other clutch parts I ordered earlier this week.
http://www.streettunedmotorsports.co...ainer_clip.htm
Never got time to call the dealer today.

You need to lick em! Give me a call sometime. You need to have another UFC fight at your place or maybe someday I can host one....

 

Are you just using the 2 that come with it or are you putting more of the wavy rings on?

 

I was just going to use what came with the kit. Should I use more?

Looks like there is no way to replace the other ring that stays on the on the pressure plate either. Or is there? This is the part that the retainer clip snaps into.