Notices
Evo Engine / Turbo / Drivetrain Everything from engine management to the best clutch and flywheel.

2k rpm idle?

Thread Tools
 
Search this Thread
 
Old Jan 1, 2011 | 08:42 AM
  #1  
evojoe90's Avatar
Thread Starter
Evolving Member
iTrader: (9)
 
Joined: Feb 2009
Posts: 125
Likes: 0
From: Jamison, PA
2k rpm idle?

my 03 evo has a high idle after driving for more then 20 minutes. cold start idle is normal. usually idles @ 1000 rpm because of cams. if i shut off the car it will go back to normal until i hit the gas, and then will go back to 2 k. please give me your advice. thanks
Reply
Old Jan 1, 2011 | 01:31 PM
  #2  
My03evo's Avatar
Evolved Member
iTrader: (1)
 
Joined: Dec 2010
Posts: 696
Likes: 0
From: Toms River
maybe bad tps or iac? or really sounds like a sticking throttle cable....when its at the high idle go to the throttle body and try to "close it" more and see if it drops back down or just rev up it and snap the throttle back to idle and see what happens.
Reply
Old Jan 2, 2011 | 05:00 PM
  #3  
evojoe90's Avatar
Thread Starter
Evolving Member
iTrader: (9)
 
Joined: Feb 2009
Posts: 125
Likes: 0
From: Jamison, PA
sometimes itll do it then itll go away a couple seconds later. revs go up and down varieing from 1k to 2k rpms. then sticks at 2k. throttle not sticking
Reply
Old Jan 2, 2011 | 05:17 PM
  #4  
meckert's Avatar
Evolved Member
15 Year Member
iTrader: (11)
 
Joined: Jul 2006
Posts: 2,110
Likes: 5
From: Denton, Tx
so you get tuned as well? Regardless, diconnect your battery to reset the ecu-- should help if not correct the problem-- sounds to me like the tune though.
Reply
Old Jan 2, 2011 | 05:48 PM
  #5  
evojoe90's Avatar
Thread Starter
Evolving Member
iTrader: (9)
 
Joined: Feb 2009
Posts: 125
Likes: 0
From: Jamison, PA
just ohm'ed out the tps and seems that the sensor is falty. goin to replace tomorrow
Reply
Old Jan 2, 2011 | 06:02 PM
  #6  
tscompusa2's Avatar
Former Sponsor
iTrader: (22)
 
Joined: Oct 2005
Posts: 5,375
Likes: 10
From: pa
you can test the tps by using evoscan, no need to ohm test it. its really just a coil.

take your idle air controller apart and clean it.. sounds like its dirty.

In an EVO the closed loop vs open loop transition is based on airflow hz, not a idle switch or anything like the dsm's.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
browningderek
AEM EMS
73
Mar 2, 2019 08:35 PM
rartist
Evo General
9
Feb 24, 2017 03:46 PM
ezzey
Evo General
8
May 9, 2016 09:40 AM
3volution8
Evo General
15
Apr 23, 2008 12:25 PM
RSGuy
Evo Engine / Turbo / Drivetrain
10
Sep 26, 2007 08:57 AM




All times are GMT -7. The time now is 07:03 AM.