Tagge

iTrader: (5)

ok so i get in my car yesterday go to start it didnt start i shut ignition off car started and drove home fine. After leaving car overnight next morning i find the car wont start and the CEL is flashing at times. Used my cheap scanner and found a code P0335 crank position sensor circuit B1. Not sure if this is common or not but here is the weird part to me when i go to start the car dash lights come on while stepping on the clutch you hear the fuel pump prime while trying to crank it but there is no crank or anything. has anyone else had a similar problem is the CPS a common part to go bad the car has just bolt ons, but has been sitting for a year or so due to a bad clutch thank you very much.

evo714oc

Check the remote cable (the thinner cable) on ur starter, kinda weird but mine does it every so often its tht dam cable tht keeps popping off, and I get tht same code

evoiao

iTrader: (10)

Did you ever fig. out what was wrong....i have had the same experience.

scrivs

Yeah me too, right after I reinstalled my newly rebuilt engine...

e v o

iTrader: (2)

I am currently running into the same issue. I just bought another used starter as back up. I checked all of the termainals and everything looks tight. I am guessing its the starter

evodriver49

iTrader: (6)

if you need a CPS lemme know!

hiboost2.0

iTrader: (15)

I just got the same code today driving home from school. I'll look into it and report back.

Ramonski

iTrader: (18)

Bumping this thread because I just had the same thing happen to me. Car won't crank, I can hear the fuel pump though and all my lights work fine. Please help lol

thestig0711

iTrader: (1)

I had an issue like this. The reluctor wheel came loose and hit the cps causing catastrophic failure of it. Check the voltage readings off your cps when cranking.

Ramonski

iTrader: (18)

^^^thanks for the advice, I'm going to try that tomorrow and also I think my starter might be fried from the cranking over and over again during the compression test so I'm going to test it tomorrow.

chubvo3388

opposite side of key on steering column (with plastic covering removed of course) goes into ignition try wiggling it while turning key heard of that wire bing faulty in couple dif cases