Please help me!!! I am installing a ACT stage 3 clutch and an alunminum flywheel. What are the torque specs for the flywheel to crank and pressure plate to flywheel. help quickly please I am starting the install in about 4 hours and don't feel like figuring out the old fshion way. thanx all jesse

 

Same here. I'm doing the clutch in the morning and have been trying to figure this same thing out all evening.

Bump

 

From the shop manual:

Flywheel to crankshaft bolts - 98 +/- 3 ft-lbs
Pressure plate to flywheel bolts - 13 +/-2 ft-lbs

Some tips:
I would use some red or green loctite on the flywheel bolts. You don't want those things backing out on you!

Also, you should tighten down the pressure plate to flywheel bolts in small increments and in a cross pattern just to make sure the pressure plate seats properly against the flywheel.

Good luck!