I pulled 2 codes on the car, P0107 which is Manifold Absolute Pressure/Barometric Pressure Circuit Range/Performance Problem. The barometric circuit that is attached to the OE intake pipe, its off on my car I have stand alone HKS F-con.... Will that prevent the car from starting?

 

I pull the MAF on, car pulled 0 code, car still did not start. So assuming that the code did not cause the car not to start.

 

Who did the initial instalaltion/tune that F-con ECU for you? Is it converted to Speed Density?

 

Its on speed density.

 

Did you pull that code using the HKS software and their serial cable or just a regular OBD scanner?

 

odbii

 

did it start up fine before? maybe your MAP sensor is faulty? imo, you should go to a oem ecu and retune for speed density. tscomptuned does tunes for many people on here and could probably get you set up.

 

I dont think its a turning issue, the last time the car really started was about 5-6 years ago. This post is piggy back on my other post on why my car isn't starting up.

I don't have a MAP sensor =)