Huh, that's interesting. I know the HTA3076 and HTA3582 and HTA3586 absolutely killed the standard Garrett GTX compressor wheels in the gtx3076r and gtx3582r. If you have a power goal in mind, you can call or email them and they will get you the right turbo. If you try, you can even get Robert on the phone sometimes, and that's pretty much like talking to a turbocharger encyclopedia...lol. The guy knows his stuff.

 

Who is Robert? How can I contact him?

 

Robert is the owner of FP/Xona. Call FP and ask for him. Amber is the one that usually answers the phone.

 

Thank you very much!

 

xona 82/67 I believe. Should arrive soon, stoked!

 

You have received the specifications of this turbine, compressor and turbine map?

 

the specs can be found on fp's website

 

Perhaps a baker, data on the site would be sufficient.
http://www.forcedperformance.net/mer...Xona-Universal
Were is Compressor and Turbine Map ?
I do mean serious graphics, accurate, which allows a correct choice and good operation of the turbine.
https://www.turbobygarrett.com/turbo...582R%20%283%29

 

Tuned an evo 8 on the Rota 82-67 on the t3 .85 housing. Put down 704awhp uncorrected on a mustang dyno. Temp in shop was 103F and 88 percent humidity when the pulls were done. It rained later that day

 

Do you have a Dyno Graph and setup info? I didn't see the graph in the Dyno results. That is the turbo I'm looking at. Thanks for the post.

Mikey

 

But for: Xona Rotor 71-64 Ball Bearing ?

 

When I stop by the shop ill pull up the dynograph from that pull and a list of the mods on the car.

 

XR95-67 / boost 39psi / fuel E85
Subaru
826WHP - Mustang Dyno (real power)

 

I'm really surprised noT a lot of people have tried these turbos yet. I'm going T3 this month and TPG Tuning here in Pittsburgh has a 7164 DBB sitting on the shelf, 4 bolt T3 flange .85 I'll be picking up this week. Hope to have hot parts soon too. I'm really excited to see what it'll do. I just sold my FP red, that I was Making 486whp on 93 octane with a mustang dyno. I'm expecting 500 on pump with the 7164 and we'll see what she can do on E85.

 

Im on a 82/67 with a tial 1.06 housing, made 500hp on a super conservative tune. My car can easily make 700+ with e85 and a 2nd pump. This is a similar to my old setup (hat86) spools about the same, its just shiny in the middle. The xonas have a stainless center piece so it wont corrode over time.