Hi Guys,
im building another 2.2L engine and i wonder will a stock Conrods withstand 10.1 compression pistons with Ron 95 fuel?

Thanks

 

Complete waste of time to build a motor and not put stronger rods in it, especially a stroker.

 

Just hoping to get some info from those who uses stock rods and achieving more than 350whp

 

My car is currently achieving more than 500whp on a stock short block. No need to even have a built motor for 350whp.

 

Agreed.

 

totally agree if your going to build your engine and have it torn down just put in a set of nice rods for peace of mind.

 

500 whp on Vd or dyno jet ? your sig says 452 whp mustang dyno which in most cases would be about 500 whp on a dyno jet.

 

The local dynojet at DynoJet HQ reads a consistent 11% higher than the mustang dyno I dyno'ed my car on. I've also turned the boost up out the top a bit. Aaron was letting it taper to 27psi when we got the numbers in my sig. I turned it up to hold 30psi with the same timing, and it makes 556whp on virtual dyno. Aaron wanted to keep it safe, I don't care that much lol.

 

Those are very solid for 30 psi/ fp red on e85

 

 

Eagle rods are cheap and are good to about 600