Valve seals or turbo seals? White smoke & oil burn smell
#151
You guys think I could be over-oiling my FP Red? Just running the oil feed line from the head.. I know the JB like to be fed from the oil filter housing but didn't think it mattered too much for the BB
Also - been reading up on the Kiggly HLA mod. Wondering if it would be beneficial to my setup..
Also - been reading up on the Kiggly HLA mod. Wondering if it would be beneficial to my setup..
Last edited by Bmurray; Jul 30, 2017 at 08:02 PM.
#152
Evolved Member
#153
It's looking like, the 10an on the VC + correct oil + FP inline filter with a .30 restrictor is going to solve my problems.
Still need to address why my valves have oil on them after the fresh seals..
#154
EvoM Guru
iTrader: (1)
What restrictor were you running previously? Just an unrestricted line from the head?
#156
EvoM Guru
iTrader: (1)
Gotcha. I'm surprised you're just now having this smoke issue (assuming it's the turbo). Even at the head, your turbo was getting about 40psi of oil pressure in the higher RPM's lol.
#157
EvoM Guru
iTrader: (9)
You guys think I could be over-oiling my FP Red? Just running the oil feed line from the head.. I know the JB like to be fed from the oil filter housing but didn't think it mattered too much for the BB
Also - been reading up on the Kiggly HLA mod. Wondering if it would be beneficial to my setup..
Also - been reading up on the Kiggly HLA mod. Wondering if it would be beneficial to my setup..
HLA is a nice piece to have.
Last edited by Abacus; Jul 31, 2017 at 11:26 AM.
#159
EvoM Guru
iTrader: (1)
Did they complete the initial inspection of the turbo yet?
#162
EvoM Guru
iTrader: (1)
So, turbo is fine. It just needs a proper vent setup for the crankcase. When mine went in for a rebuild its at 48cfh of leakage, and still didn't smoke with proper crankcase venting.
#165
EvoM Guru
iTrader: (1)