The write up says tap in to the FPR line, some people say tap in to the BOV line, can anybody throw in their 2 cents and tell me where the best place to tap in your boost gauge to?

 

The FPR....it has a white line on it.

 

http://evomoto.com/tech_info.php?tPa...f7c76b865974e9

 

That line isn't accuate. Tee the line beteen the solinoid and the intake manifold.
http://www.evotuners.net/forums/showthread.php?t=644

 

ok that seems like they are talking about the same line, ok so off the intake manifold there is 1 thats higher up and only about 4 inches long runs right back in to the intake mani from the connector and the other 1 that looks like its from the same connector runs to the fpr, witch is it the shorter 1 or the 1 from the connector to fpr, i would think the shorter 1 since its a direct port from the intake mani on 1 end,

 

I heard Fuel Regulator, But Any Vaccum on the Manifold Close to the Fuel regulator should doo, just make sure you clamp them down good.

 

+1

 

I tapped the fuel reg line.. Reads as it should

 

FPR line. Its very easy to do! don't cut the original line. Just remove it, connect the T connector and connect a 2 inch line on the FPR. Tie wrap everything to secure...

 

yup what ^ said will do