😂

Yeah, there's enough room under my Sequoia to get to everything. It sits 48 weeks out of the year so plenty of spider webs!
After I replace these and wire in new O2 sensors, I'm welding a skid plate on. Let them cut that ***** off.
I'm not too mad, as my old converters smelled like rotten eggs anytime I got on the freeway, anyway.

 

Still sucks since ca replacement cats cost so much. Skid plate under it would definitely work!

not really worried about my other car I keep outside since it's low and the cat is right off the turbo. No way to get a saw above it. Plus I live in the ghetto and people don't go to the ghetto to steal haha

 

I'm actually buying Federal converters and registering it along with the Evo with my company. From now on it's a company vehicle. The trailer will match.
I will no longer have to pay registration on either, seeing how anything after 12 years old is a permanent registration.

 

I haven't DONE it yet.... But these just showed up.

 

Kenwood KDC-BT378u ...welcome to 2011, baby!

 

hahaha I have an alpine single din. Talk about old school!

 

same.

 

And this is replacing the Alpine I've had since...2007? Maybe 2008.

 

Keeping it old school!

I bought the Gruppe-S triple gauge pod so I'm gonna have to relocation the radio sometime soon. I didn't want to hack up the dash metal to move the hvac down low.

 

does anyone know what’s the problem with the code and sometimes my car runs and sometimes it does not

 

map sensor is my guess happened to me

 

P181F MITSUBISHI Code - Clutch 2 Pressure High Range Out

|What are the Possible Causes of the P181F MITSUBISHI Code?

• Faulty Clutch 2 Pressure Sensor
• Clutch 2 Pressure Sensor harness is open or shorted
• Clutch 2 Pressure Sensor circuit poor electrical connection

|How to Fix the P181F MITSUBISHI Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

 

. Ojhz

 

I was able to mount my LICP, Ran some of my boost controller lines, installed my wastegate, installed my radiator and filled it.

 

Upgraded my reservoirs