I need the isc o-ring part number and the o-ring that is inside the throttle body on the side.

Thanks

 

Any one know?

 

I always PM RussellM for any oem part inquiries

 

All of the part number requests go in here : https://www.evolutionm.net/forums/ev...t-go-here.html

A lot more likely to get an answer there.

 

Ok ill try there, thanks.

 

Any one know, i can't seem to get an answer.

 

call you local dealer parts department... thats probably where you're gonna have to purchase it anyway. i havent seen to many companies selling TB o ring kits...

 

you can not get the o-rings separate from the throttle body through the dealership. i would suggest to go with the milspec throttle body seals. picture did not load for me the 1st time seeing the thread so i dont think the milspec seals are what you need.

 

This is the o-ring i need, just wondering if anyone new what is was off hand. If not i will go to the dealer tomorrow.

 

Dealer said they can't get the o-ring... I guess im just going to measure it myself and find one.

 

Does anyone know what this part is called?

 

actually the other guy had a good point... mil spec or whoever else ports the tb might have em... since the break down the tb almost completely they probably have some of these on hand... you might wanna call them and ask. if not a decent oring kit should have it...

 

Ya i found the o-ring but does anyone know what to call that part.

 

I would say go to your local auto parts store. They usually have a assorted o-ring set in metric and in standard. Buy both and then just find one that fits best.

 

Mine is leaking as well. What did you end up doing and did you figure out what that part is called and what it does? I ended up spending over $200 for a new TB. I measured my o-ring at 7mm id and 8mm od. I need to measure the thickness of the ring too.