Launch Control AFR's??
#1
Launch Control AFR's??
I was just testing the launch control / 2 step on my evo 8
it is from a tephra rom V7, (my car didn't came with a rev limit stationary), left it at 5k rpm
Works great, but my wideband goes lean (20 afr) when the launch control / 2 step is on
Shouldn't it go rich? since ignition is cut???
Is this ok, being lean during the 2 step?
Thanks
it is from a tephra rom V7, (my car didn't came with a rev limit stationary), left it at 5k rpm
Works great, but my wideband goes lean (20 afr) when the launch control / 2 step is on
Shouldn't it go rich? since ignition is cut???
Is this ok, being lean during the 2 step?
Thanks
#2
Evolving Member
No Fuel gets cut not ignition,
You will need to fatten up the AFR Map in your Launch Control fuel map,
Set it for around low 9's and test it, then adjust from there
You will need to fatten up the AFR Map in your Launch Control fuel map,
Set it for around low 9's and test it, then adjust from there
Thread
Thread Starter
Forum
Replies
Last Post
Charlie_B
Evo Engine / Turbo / Drivetrain
10
Jul 1, 2007 06:49 PM
2StepsAhead
EvoM New Member / FAQs / EvoM Rules
7
Jun 9, 2006 05:29 PM