For my next setup I wanna run 275 tires or at the least 265. How can I do this without rubbing if at all possible with no fender modification. Advice greatly appreciated

 

get an 18x9.5 +40 enkei NT03 or a 18x9.5 +38 enkei rpf1

both will require a 20mm spacer to clear the front brembos

 

You're still going to have to roll the rears, and possibly/probably run a 5mm spacer out back as well.

 

Enkei GTC01, 18x9.5+38, no spacers, no rolling front or rear and running 275's. Plenty of clearance for the brembo's with this particular wheel. You will have a slight rub on hard lock when parking but other than that things will be fine. I'm lowered on GTWorx springs and have ran multiple track days with this set up.

 

Bro.

Do you even search?

https://www.evolutionm.net/forums/ev...el-thread.html
https://www.evolutionm.net/forums/ev...re-thread.html
https://www.evolutionm.net/forums/ev...s-go-here.html
https://www.evolutionm.net/forums/ev...ly-thread.html
https://www.evolutionm.net/forums/ev...elocation.html




Viegasjuice, you post a new thread about an old topic covered on EvoM many many times before like once a week.

 

Nice, I haven't seen results of the GTC01's yet. I would still throw a ~10mm spacer up front since you have the space to the outside, or should have it. But then again, if it works, it works.

 

Wheel specs in my sig. 20mm spacers needed in front and lots of rolling all around. Coilovers needed also

Im running -3 camber

 

I was planning on running some xxr wheels for now. Main thing I was trying to avoid is rub during hard turns.