hey guys,

i was isntalling my titek o2 housing tonite.When i was removing the bolts,one of them was badly stripped.So now i have to get a replacement bolt,but what should i do for the hole that the bolt goes into?

also one of the nuts was stripped so i'll be replacing that and the 'threaded shaft' that it screws onto.will that just screw off?thank you

pj

 

Yeah u just need to get a stud remover.

 

how do i re-thread the hole?using a tap?

 

Yeah, Hopefully it can be retapped. I just had to actually go get some of this done of the 10.5 hotside i just sold. Best thing to do is just call a shop or to and ask if they can do it. Or if you have a machining shop near you that would be even better. I got my stud, not drilled, but welded out and it was only $20. Goodluck man!