ARP Head Stud Torque Setting???
#1
Evolved Member
Thread Starter
iTrader: (22)
Join Date: May 2003
Posts: 994
Likes: 0
Received 0 Likes
on
0 Posts
ARP Head Stud Torque Setting???
I need the torque setting for the ARP head studs. Anyone know what it is? Yeah I searched...everyone has covered who will do them and how to do it yourself but no one has said anything about the actual torque you have to do these at.
#3
Evolved Member
iTrader: (11)
Join Date: Aug 2003
Location: Kansas City
Posts: 759
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Dragon41673
bump
bump
#5
Evolved Member
iTrader: (11)
Join Date: Aug 2003
Location: Kansas City
Posts: 759
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Dragon41673
Thank you KC...once again! I didn't even look at the install instructions yet. Haven't even cracked open the boxes yet either. I'll look later tonight.
Thank you KC...once again! I didn't even look at the install instructions yet. Haven't even cracked open the boxes yet either. I'll look later tonight.
#6
Evolved Member
I am not home but 65 ft/lbs was what I remember from the Evo manual.
So you just pull out the bolt, put in the stud and crank it down, then use the torque setting
on the nut. Don't forget the washer of course.
So you just pull out the bolt, put in the stud and crank it down, then use the torque setting
on the nut. Don't forget the washer of course.
Thread
Thread Starter
Forum
Replies
Last Post
itsmrrizz2you
Evo Engine / Turbo / Drivetrain
24
Dec 8, 2013 01:04 AM
turboDan
Evo How To Requests / Questions / Tips
86
Oct 26, 2012 12:47 AM