HVAC repair. Installing revised gears and a new control cable.
http://www.youtube.com/watch?v=vcG20LmRZFU

More evo how to videos here:
http://boostedfilms.com/joomla/videos/how-to-videos-car

 

subscribed! thanks for the vid

 

Great Vid again! Wish my fix was that easy, but the gears didn't help, so the blend door is to blame.

 

Man, you sure like weight savings.

Luckily, I didn't have to go through all that and just had to do the gears. Was really easy to do.

 

very nice!
found it. heres the part numbers
Part # Description
MR979515 Wire+heater Contr
7801A110 Link+heater Air C

 

nice video. my heater knob just binded up last week. how much were the parts ?

 

good thread

 

Thanks for the video.

 

Not much, I think it was under $25 shipped for both.

 

nice! bookmarked

 

For those of you on the cheap (a friend of mines Lancer) that only have the bent cable issue, take all the gears off and clean/re-grease them as shown in the video. For the stock cable, straighten out where it bent. Then with a razor knife and wire strippers strip off 2.5" of the black sheathing. Now grab the soldering iron and fluxed solder, solder the exposed area lighty. Glide the soldering iron from one end to another, only leaving a bit of solder on the cable. Your main goal is to weep the solder into the cable rather than have it on the outside. So far this has lasted a full year on his car. Results may vary but it sure can't hurt to try.

 

great job, thanks

this is such a common issue too

 

fck yea mine is almost done thanx for this vid

 

Nice video

 

Great video! I need to do this soon.