Im gonna be installing aem wideband , aem boost and aem oil pressure .. Im wondering if i can get the power of the 3 of them from the cigarette lighter or it has to be from different places???? .. Ive always installed the gauges from the cigarette lighter before on other cars i dunno on this one.. Also can i install the ground of the 3 together from
The same place all
Of them ... Help is appreciate thankssss

 

Any 12volt power source that is turned on by the ignition switch (cig lighter) is suitable to splice into. I've run many gauges in series (one after another) on the same common power source with no ill effect. Also, the ground is pretty simple. All electronics in a car are connected to a common ground, the frame of the car. Find a ground and source it as you own. If that isn't convenient, which I've never not found a common ground, take sand paper or a dremel with a grind wheel, clean off paint, drill a hole in metal, and use a self taping screw to ground any electronic

 

So i can use the the cigarette lighter for the 3 power and the same ground for the 3 pf them

 

Yeah pretty much.

 

Also what is the best place to put my wideband sensor

 

I had a issue with the Cig lighter get a pigtail Fuse and run it off the fuse box location. Solder and heat shrink all the wires. Get the Pod from a vendor that goes where the radio is or locate a Gruppe-S Panel. Their hard to find but worth it.