fender rolling pix :)
Originally Posted by Speed Element
unless you are running super crazy offset, this type of fender rolling will allow you to run up to 265 size tires on evo on 9-9.5" width wheels. anything bigger you will definitely warp the fender after awhile.
I don't understand what you are referring to "warp the fender". What do you mean by that??
I am running both 285/30/18 Advan Neovas on 18x9.9+35 wheels, and 285/30/18 V710's on 18x10+32 wheels, and with the fender lip rolled all the way up it does not run anywhere on the inboard or outboard side of the fenderwell. The only place it did rub was the bolt/screw that hold the fender to the rear quarter panel right by the edge of the wheel well. Just shaved that off and moved it back about an inch.
EVOlutionary
warping the fender happens when you try to push on the lip too much instead of rolling it.it happens more on the panel side when you try to force rolling the fender.i did that a little bit on the driver side of my car since i tried rushing it 
its hard to fix that area since its bonded to another piece inside.
its hard to fix that area since its bonded to another piece inside.
Thread Starter
Former Sponsor
iTrader: (270)
Joined: Dec 2005
Posts: 3,569
Likes: 1
From: San Jose, CA
Originally Posted by evo_dadi
warping the fender happens when you try to push on the lip too much instead of rolling it.it happens more on the panel side when you try to force rolling the fender.i did that a little bit on the driver side of my car since i tried rushing it its hard to fix that area since its bonded to another piece inside.
its hard to fix that area since its bonded to another piece inside. thanks evo_dadi
Thread Starter
Former Sponsor
iTrader: (270)
Joined: Dec 2005
Posts: 3,569
Likes: 1
From: San Jose, CA
Originally Posted by occultworks
How much does this tool cost? Can I pick one up at a Napa or something similar?
its about $200
Thread Starter
Former Sponsor
iTrader: (270)
Joined: Dec 2005
Posts: 3,569
Likes: 1
From: San Jose, CA
Originally Posted by Revolver Ocelot
Hey Cal, do you think a slight pull would be hard on the Evo's rear quarter? Ive never seen it done before.
If you push too hard on the fender it will cause warping of the fender. I did that on my car a little bit. 
You can only see it in certain lighting however.
You can see it in this photo a little:
http://www.norcalmotorsports.org/use...o062406_02.jpg
This will fit 275's no problem though.
You can only see it in certain lighting however.You can see it in this photo a little:
http://www.norcalmotorsports.org/use...o062406_02.jpg
This will fit 275's no problem though.
