CBRD Tune ECUFlash
Evolved Member
Joined: Oct 2007
Posts: 1,849
Likes: 1
From: USA
So Chad, what's the update? Was cobb lacking control over what ecutek called the "trustful airflow against torque tables" and "trustful airflow check tables," but now added them? Share the goods! Anyway, keep up the great work man. With you guys all working on this, this issue will be a thing of the past soon. 
So Chad, what's the update? Was cobb lacking control over what ecutek called the "trustful airflow against torque tables" and "trustful airflow check tables," but now added them? Share the goods! Anyway, keep up the great work man. With you guys all working on this, this issue will be a thing of the past soon.
just working on some software updates, faster flashing etc...
they do an excellent job of updates... we love their subaru software....
cb
Thread Starter
Newbie
Joined: Aug 2008
Posts: 54
Likes: 0
From: Harrisburg PA
I went to CBRD today and recieved a flash. It did not solve the issue.
My issue happens anywhere between 2000-4000rpm, if I floor it I get the CEL and Limp. If I am above 4000rpm and floor it doesn't happen.
Will a lean condition at the lower rpm cause a CEL?
My AFR at those lower rpms was around 15:1 which I think is to spool the turbo quicker.
My issue happens anywhere between 2000-4000rpm, if I floor it I get the CEL and Limp. If I am above 4000rpm and floor it doesn't happen.
Will a lean condition at the lower rpm cause a CEL?
My AFR at those lower rpms was around 15:1 which I think is to spool the turbo quicker.
tim,
14.7-15 are standard stoich for non boost conditions..
the X also likes a leaner on boost afr than the previous generation cars..
I just found some extra little things to change
im going to test it tomorrow ill let u know
cb
14.7-15 are standard stoich for non boost conditions..
the X also likes a leaner on boost afr than the previous generation cars..
I just found some extra little things to change
im going to test it tomorrow
ill let u knowcb
Thread Starter
Newbie
Joined: Aug 2008
Posts: 54
Likes: 0
From: Harrisburg PA
Thread Starter
Newbie
Joined: Aug 2008
Posts: 54
Likes: 0
From: Harrisburg PA
So Chad, what's the update? Was cobb lacking control over what ecutek called the "trustful airflow against torque tables" and "trustful airflow check tables," but now added them? Share the goods! Anyway, keep up the great work man. With you guys all working on this, this issue will be a thing of the past soon.
They both have access to all needed maps
Al
Evolving Member
Joined: Feb 2007
Posts: 286
Likes: 0
From: Out in the Country
Thread Starter
Newbie
Joined: Aug 2008
Posts: 54
Likes: 0
From: Harrisburg PA
