Im getting ready to install a aem meth injection kit and im not sure about a couple things. Where is a good place for the nozzle, and where do these 2 wires connect too?
Green wire, Boost-Safe output for timing retard or boost dump solenoid. 1.7a Max
Blue wire (opt) 0-5vdc pressure signal. (.328v = 0psig, 5vdc = 38psig)

Im using a mbc so I have no clue about these wires and ive never installed one of these before.

 

put the nozel right before the throttlebody.

wires? id have to research.

 

I talked to AEM and the two wires are used if u have a EMS set up, so I wont be using those wires. Does anybody know any safety devices to use if the pump or injector fail?

 

Have a browse of the WAI forum under Evo VIII and IX Engine Mgmt and Tuning.

 

Thanks, that led me 2 this product that i can use with the aem 12v fail safe wire
http://www.labontemotorsports.com/st...ow/BBK-10.html

 

if your interested in a failsafe, i carry the snow performance safeinjections...fresh new design as of 3 weeks ago...