ice1874193

what did you use for the ac (or power steering) line?

c_reber

iTrader: (13)

Black Wire loom. Mentioned it a couple posts up too

p.phresh

iTrader: (1)

did you guys have to remove the front bumper to get at the AC line?

JaxRRevoX

iTrader: (1)

no, just take off your stock plastic cooling plate and you get get to it, and its the power steering line not the A/C line......

Fishstix

iTrader: (1)

This will be a good project for my day off...

After I pop the emblem out of the plastic holding, what should I use to paint it? I want to make it red. Spray paint? I should sand it down first, right?

And after I paint it with whatever, what do I use to finish it?

And is there a specific thread that shows how to take off the front grill? Or is it just common sense. Any help is much appreciated.

JerseyEvox

hey is there any way to debadge that front badge without having to take it to a shop? diy? also has anyone taken out the black plastic panels on both sides of the intercooler in order to see the intercooler pipes?? i really want to do that

PhilhasEvolved

once you take the front emblem off, get some sand paper or scotch scratch pads and sand it until its dull. then wash it off and let it dry. once its dry put a couple LIGHT coats of high heat engine enamel paint. It holds up the best. Let it dry and then adhere it back to the grille. You can get the paint at pep boys and its only like 5 bucks for a whole can.

AWDTerror

iTrader: (2)

You can just take a dremel and cut it off yourself.

And the black panels next to the intercooler are there for a reason.

Evo-X-FTW

iTrader: (1)

yes, like said earlier use black wire loom for the ps line. i painted mine first and it ended up having 100 little rock chips in it and looked worse than doing nothing to it. then i went to the loom and its perfect!!!

shawnburch

What size wire loom did you use?

oftheheavens

iTrader: (1)

Used plastidip on the line and plastic paint flat black on the emblem

mwmr

Where did you get those white buttons to plug the holes where the license plate frame was drilled?

uhhhson

iTrader: (4)

you can probably just get those from home depot

Dr1fter

iTrader: (1)

And another S. Florida Evo X owner....I swear we are a rare breed down here .