dont know much about that ECU. I wonder if it set up for anti-lag? Especially since it says "FOR RALLY" on it. Best bet is to contact Mitsu or Ralli-art JP and get more info.

 

ok well all im new to these an especially evo's i just bout an evo 9... so tryin to figure out where to begin with moding it..i used to own an 03 Oz which i did alot of work to but the evo all lot better and im very happy with my upgrade...i did alot of searchin on here an alot of people have diffrent ideas..im lookin for speed/acceleration..maybe will do some track so any help yall can provide would be most appreciated

 

Very honestly I have been reading up MLR website. There are tons of evo6 owners there. I would have opted for ECUTEK however since I'm in Bangladesh it will a little tough for me, as a result am taking the ralliart route.

It has a little more aggressive map than the standard ecu (just plug and play). No fuel cuts, with a fuel pump, exhaust, intake, boost controller I should be good for 340-350hp at 1.5bar.

Am also getting the cable and evoscan for datalogging purposes. Might go for a flash in the future.
www.limitless.co.nz/evoscan

There is a lot of info on the Ralliart ECU in this website.
http://www.lancerregister.com/showth...p&pagenumber=1

BTW, took a couple of night shots of my interior.



A few more day shots.