I know. That's why I called midnight EST

 

He didn't answer? I have never gotten a machine, he always picks up. You can call Richard too, he is always there, sometimes even later then the website says. I wouldn't wait for him to call back, just keep calling until you get him on the line.

 

There are holidays in Auss so you may not get Richard till Feb, Not sure on Ian but its worth to try a few times without getting upset as he can be out tuning also.

Mark

 

any mention of individual cylinder retard with the knock module?

 

Yes there will be.

Mark

 

Is this going to be a seperate unit available from Autronic, and will it be available for us PNP folks?

 

It is for the SM4 based pnp unit and will plug in to the knock socket already fitted to the ecu.

Mark

 

and for the non-pnp SM4 guys?

 

As far as I know but you would need to ask Richard or Ian at Autronic on it,
The Non pnp wont currently be avl as they are still trying to work out what is needed due to the diff engines this can be fitted to as they want to be sure it will work as it should on all engines,
The knock board may fit in the SM4 as I did ask about this a while ago but they were looking to amke sure if it was being used like this that it would only work on a engine with the same shap combustion chamber as tested on, i.e the Evo board would only be fitted and working on the Evo trigger pattern,
The other way to use knock control would be to fit the Evo Sm4 pnp from the 3 plug unit to a 4 plug Evo loom as this would work.

Mark