I am doing a rack & Pinion on my car and tried to remove the lower ball joint but could not remove so I just removed the A arm off the sub frame. When I used a Ball Joint fork grease came out of the boot. Can I have the shop repack it or do I need a New ball joint. I don't see a fitting to re- grease.

 

You do realize this is an engine management/tuning forum right?

 

Could not find a suspension and steering forum...To answer my own question I got back from shop I have two options 1) replace the ball joint 2) use a needle nose tip on grease gun and pump grease back in where it leaked out. Just to let anyone know what to do if this happen to you

 

Let me help you a bit -> https://www.evolutionm.net/forums/ev...-tire-rack-23/

 

thanks