02 Lancer ES Turbo Project
#811
Evolved Member
iTrader: (5)
#813
Evolved Member
iTrader: (7)
Join Date: Sep 2003
Location: Austin, Tx
Posts: 1,509
Likes: 0
Received 0 Likes
on
0 Posts
also, log the wideband...which one do you have?
Edit, nvm....you have the AEM UEGO...so you'll need to connect the proper wires to a serial connector, and plug that up to your laptop (if you don't have a serial port, you'll need a usb to serial adaptor)
http://forum.aempower.com/forum/inde....0;attach=4365
or https://www.evolutionm.net/forums/4082581-post14.html
Edit, nvm....you have the AEM UEGO...so you'll need to connect the proper wires to a serial connector, and plug that up to your laptop (if you don't have a serial port, you'll need a usb to serial adaptor)
http://forum.aempower.com/forum/inde....0;attach=4365
or https://www.evolutionm.net/forums/4082581-post14.html
Last edited by HornstarBU; Jul 30, 2010 at 11:10 AM.
#814
ok well I tried logging with evo scan and im not sure exactly how to work it. is there a thread or vid I can view to see how this works? I hit start logging, and it says link engaged, then 5 seconds later it says the same thing again? im not sure what im doing wrong
#816
I got it fixed it was my cable trying to come out. here are my logs from earlier, I cant log afr until I get that serial port. I boosted quite a few times today. cel comes on and blinks on and off when im into boost, I changed up the injector scaling if I go higher it leans it out and if I go lower it richens. I think its at 408 as of right now and I raised it earlier to 416. not sure but my afrs are still staying at 10.0 when im about to go in boost, I cant seem to lean it out. but when im idling afrs are around 14.7-15.0 which I will take that. its just the boost thing. Also how can i lower my ilde down to 800 something rpms?
Here are the logs from evoscan
Here are the logs from evoscan
#824
Evolved Member
iTrader: (7)
Join Date: Sep 2003
Location: Austin, Tx
Posts: 1,509
Likes: 0
Received 0 Likes
on
0 Posts
I remember reading the post about scaling maf for leaning out at the top end....but never a for sure, end all answer, that is necessary though, to change the maf smoothing in the upper end?