Hey everyone have some forged pauter rods on ebay, just type in lancer rods at ebay they will come up. One had a bearing spin in the conneting cap so one rod needs to be replaced, i called pauter myself and they said they could reproduce one if you have the spec sheet card which i have for them and the numbers off the rod. Be sure to read the discription on the item for more info. ONLY ONE MORE DAY ON THE BIDDING. Link to the auction http://cgi.ebay.com/ebaymotors/ws/eB...spagename=WDVW

 

Saw that auction already, just wish I had the $$$ and the know-how. Good luck though.

 

Not too much know how needed though.

 

Like Ryan said, it really isn't as difficult as you'd imagine.

 

It's not that difficult. As long as common sense is on your side. Nothing like spinning a bearing on a $700 set of forged rods.

just kidding

 

It's only bearings.... costs about 120 bucks for new bearings, assumin no damage to the rods.

 

I know ur just kidding but when your bearings have a nitrous and a turbo explosion, 60,000 miles and then after all of that a new 2600 act pressure plate they were screaming CHANGE ME! But boy a thrust bearing went and i had major crank walk so bad that when i pushed the clutch in you could hear and feel the crank push into the cradle while rotating, it was the worst sound i have ever heard!

 

I reposted the rods on ebay starting at 250.00, if you have ?s pm me.

 

C'mon. It's already a stretch leaving this here. Don't continue to try to sell them in this forum...

 

Sorry!?

 

If you want to sell these accordingly, put up a thread in the 'For Sale' section. I'd take these off your hands for you, but I'm not sure about the integrity of the rods. Sorry.

 

My bad still learning.