So now I'm getting p0101 MAFS voltage performance problem. But the MAFS is brand new and I didn't have to splice it. Not sure yet why I would be getting that error. Could it be because I haven't readjusted the TPS to 13 yet? It is currently running at 9.5-10.5

 

Finally got the codes worked out. And finally was able to adjust the TPS. Very important to use a volt meter and check the signal wire. Need to be sure the key is on and turn the TPS until you are between 335 and 935 mv. Now the car is running much better. Still need to replace the cats and o2 sensors though. So I will provide a further update after that has been completed.