NEED a PIC of 4G94 engine
#17
Evolved Member
Thread Starter
iTrader: (5)
Join Date: Jul 2004
Location: Chicago
Posts: 2,387
Likes: 0
Received 0 Likes
on
0 Posts
And there is definitaly something going on under my valve cover but what exactly I don't know
You can check out my thread.
https://www.evolutionm.net/forums/sh...77#post2173177
You can check out my thread.
https://www.evolutionm.net/forums/sh...77#post2173177
#20
Evolved Member
Thread Starter
iTrader: (5)
Join Date: Jul 2004
Location: Chicago
Posts: 2,387
Likes: 0
Received 0 Likes
on
0 Posts
As far as I am concern I can have a big a$$ hole in the valve cover and it wouldn't bother me what bothers me is what caused it. If my valve cover is getting some oil on it and it damages the surface than who cares but what if it is from the inside?
#25
Evolving Member
iTrader: (1)
Join Date: Aug 2002
Location: San Antonio, Texas
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
well, i don't see what you are talking about either But, do you by chance happen to have your stock oil filler cap? It seems that a lot of after market oil caps tend not to seal well(oil tended to seep out a little from in between the cap and valve cover even with a gasket). I have a nice injen oil cap but i took it off since it wouldn't seal well until i bent the part of the bottom of the cap that holds it in place to the valve cover, but then it also got really hot at the same time so i just put the stocker back on, seals well and doesn't burn the **** out of my hand. just a suggestion
#26
Evolved Member
Thread Starter
iTrader: (5)
Join Date: Jul 2004
Location: Chicago
Posts: 2,387
Likes: 0
Received 0 Likes
on
0 Posts
I do have the original oil cap on but it leaks. The thing I am looking for on the pics I have asked you guys to post is the area around the oil cap, metal part of the valve cover. Since my oil cap started leaking it looked like that area got burned. The surface is uneven and a bit rough. Not a lot but you can see a bit of it on the pics. Now I have a cheap a$$ cap from an autozone and it seems to be working just fine. It does not get hot and holds the oil in place.
I guess I shouldn't worry about it.
I guess I shouldn't worry about it.
Thread
Thread Starter
Forum
Replies
Last Post
joshua webb
Lancer Engine Management / Tuning Forums
8
Feb 18, 2017 12:41 PM