Does anyone know how to program a keyless entry remote on a 03 OZ Rally??

The instructions I got were:
(1) ENSURE IGNITION SWITCHED OFF.
(2) ACCESS DATA LINK CONNECTOR (DLC)-DRIVER'S SIDE FASICA.
(3) JUMP DLC TERMINAL 1 AND GROUND.
NOTE:TERMINAL 1 MAY ALSO BE GROUNDED USING DIAGNOSTIC EQUIPMENT CONNECTED TO THE DLC.
(4) WITHIN 10 SECONDS: PRESS HAZARD SWITCH SIX TIMES.
(5) DOORS SHOULD LOCK AND UNLOCK TO CONFIRM REGISTRATION MODE.
(6) PRESS AND RELEASE REMOTE TRANSMITTER LOCK BUTTON.
(7) WITHIN 10 SECONDS: PRESS REMOTE TRANSMITTER LOCK BUTTON TWICE.
(8) DOORS SHOULD LOCK AND UNLOCK TO CONFIRM REGISTRATION.
(9) IF REGISTERING ADDITIONAL REMOTE TRANSMITTERS,WITHIN 1 MINUTE: REPEAT BUTTON PROCEDURE FOR EACH REMOTE TRANSMITTER.
(10) DOORS SHOULD LOCK AND UNLOCK TO CONFIRM REGISTRATION.
NOTE: TO EXIT PROGRAMMING MODE: REMOVE KEY FROM IGNITION OR REMOVE JUMP LEAD.

But when I hit the hazards 6 times the doors do not lock/unlock.

 

https://www.evolutionm.net/forums/sh...ghlight=remote

 

yeah guess the instructions I had are right, are there some 03 oz rallys without keyless entry?

 

Not that I know of... I don't even think it's an option. You HAVE to take it

 

this works just did it

 

holla

 

works, a good ground is everything.