raven was there last year as well.

Steve

 

Ya I know ahha.. aww so Molly won't be posing on your car???

Pittspeed will be bring the PINKS Project car....

 

ill be there nothin else to do and its a hole 5 mins away

 

hahah nah, molly is a good girl, i don't and can't view her in that way. shes a smart and nice gal. Now raven on the other hand, she can model whenever and on whatever she wants.


Steve

 

We've all seen Raven's ******. Let's try something unique and see if she can find more then half of the grammer errors in OZRalley's posts.

Two drinks says she can.

 

hahahahahahahahahha that could be the best thing i have heard in a while...

Steve

 

cant help it at times

 

Ha Ha OK Steve.. but she will still be there half naked posing on Frank's car Im sure....

 

Am i the only one that is missing brads point?

Steve

 

Very cool! Thanks! I will take ya up on that!

 

Hello all. I installed my boost gauge and connected it into the rubber hose from the FPR...I just read a post by Al from DynoFlash that said it should not be connected there. Anyone else do it that way? Any problems? Where else should it have been connected?

Thanks!

 

dont connect it there. Take it off the BOV, or the one port off the Throttle body. One is before the throttle plate, one is after, you want the one after. DOnt interrupt the vaccum to the FPR. I have seen it cause fluctuation in tuning with Pressure change.

Mark

 

Thank you Mark. I guess I'll have to fix it. I should have asked here before I followed one of the "How-To" write-ups.

-Denny

 

Anyone other than me and steelcity heading to the track tonight.

 

OK, yet ANOTHER desperate post from me

Anyone know where I am able to get 1/4" outside diameter high pressure line like the line that comes with the Snow Meth/Alky kit? I bought the kit, but used the stock wiper tank and mounted the pump in the wheel well under that tank. Now I have to run the line from there to the engine and do not have enough of that line.

I've tried everywhere in my area that I can think of, but no one has anything like it. It says it's 400 PSI on the side, and the best I've found was 140PSI line.

I know I could call Snow and get it delivered, but I have been pushing hard the last week trying to install all of my mods because I would LIKE to get tuned tomorrow at Buschur. I did not plan on doing the Meth kit originally - just picked it up last week, and had planned to just have the ECU set at a specific boost so I was not going to use the MBC. Well now I'm going with the Meth, need the controller, and I'm sure I'm pretty much screwed. I know it's my own doing, but anyone with suggestions for help, I would appreciate it!