local Pittsburgh Meet
Oh and I forgot, ground should be obvious, but just find any piece of bare metal and get a crimp on spade clip. Make sur e the negative battery terminal is off when playing with 12 v. It can hurt! Worse than AC.
Did you order the install kit? I think you'll need it. That has the proper hose.
No i didn't know anythinga bout an install kit, i figure if u order a boost gauge, they would send everything u need to hook it up
I'm not sure what all you need, but this is what I did. For illumination, you just need to tap into the dimmer switch's green w/ white stripe wire. Or also, the cigarette lighters green w/ white stripe wire. For a 12 volt source constant, you can use the Radio harness's black w/ red stripe wire. For a 12 volt-ignition-on you can tap the red cigarette wire. As far as the boost tap goes, you can tap the vac line on the the fuel pressure regulator. It's the short line that has a plastic loom around it. It's only about 4-6" long. I'd be more than happy to help you install it. Pm me if you need any more info. I'm pretty good with the gauges. For alternative installations, you can just use an "add a circuit" and plug it into the in cabin fuse box where you have an empty slot. To verify if it's ignition on, or constant, just take a meter and see if you have 12 v when the car is just in ignition on. I think I used the sunroof slot, because I do not have a sunroof. There are a few other options as well. Let me know if you need more help.
good tech there brian
well how was everyone's weekend?
autocross for a cure was a hell of a good time yesterday. course was a little tight, but all in all it was fun.
and damn am i impressed with the car. the new tune made it an animal on the autocross course. i was very happy with my times, but i couldn't stay away from the cones all day. haha.
it's alright though, compared to alot of the other drivers, i actually hit alot less cones. very tight course in spots. the power delivery is much better now though, and i am even starting to be able to throttle steer a little. it's excellent.
jeremy took fastest time of the day, so many congratulations to him, but i have to bust his ***** a little because i am almost as fast as him in a straight line now.
now i just need to figure out how to drive like he does. haha.
so as always a real good weekend, and the NHSCC raised a good bit of money for the MS foundation.
anyone else been up to anything fun this weekend?
autocross for a cure was a hell of a good time yesterday. course was a little tight, but all in all it was fun.
and damn am i impressed with the car. the new tune made it an animal on the autocross course. i was very happy with my times, but i couldn't stay away from the cones all day. haha.
it's alright though, compared to alot of the other drivers, i actually hit alot less cones. very tight course in spots. the power delivery is much better now though, and i am even starting to be able to throttle steer a little. it's excellent.
jeremy took fastest time of the day, so many congratulations to him, but i have to bust his ***** a little because i am almost as fast as him in a straight line now.
now i just need to figure out how to drive like he does. haha.
so as always a real good weekend, and the NHSCC raised a good bit of money for the MS foundation.
anyone else been up to anything fun this weekend?
Well most of you know the Evo is gone 
I still have my winter wheels and winter tires, so if anyone is looking for a setup let me know. Wheels are 5Zigen black w/ polished lip. The clear film they put over the polished part needs removed and then cleaned for them to look good again because it's peeling. I can probably do this for you if you want 
I also have a set of almost new Pirelli 210 Snowsport tires...
http://www.tirerack.com/tires/tires....+210+SnowSport
Looking for $450 for everything. PM me
I still have my winter wheels and winter tires, so if anyone is looking for a setup let me know. Wheels are 5Zigen black w/ polished lip. The clear film they put over the polished part needs removed and then cleaned for them to look good again because it's peeling. I can probably do this for you if you want I also have a set of almost new Pirelli 210 Snowsport tires...
http://www.tirerack.com/tires/tires....+210+SnowSport
Looking for $450 for everything. PM me
Denny,
Whenever you get a chance man, no rush. I might want them, if not we get people calling about 5zigen wheels all the time, so i will just direct them your way if i can't get them.
Steve
GNV Motorsports
Whenever you get a chance man, no rush. I might want them, if not we get people calling about 5zigen wheels all the time, so i will just direct them your way if i can't get them.
Steve
GNV Motorsports
You have to use the lil plastic vac. line with the compression connector off the gauge and then that install kit comes with a small rubber vac. line that slides over the hard plastic line and then onto the T and then you just install the T in the FPR line or just tap into the existing line for the MR gauge like dave said.
The installed kit comes with the line, the T, and that little splicing hose...its pretty cheap and again just makes life easy.
I was awarded this morning once again with one of my favorite pieces of paper! A fuqing ticket. Ran a red light in Dormont or South Hills, whatever the hell it is. I'm not even trying to fight this one. That's number 4! No I haven't and will not learn my lesson! I think I said the same exact thing after posting the last one, lol!
I was awarded this morning once again with one of my favorite pieces of paper! A fuqing ticket. Ran a red light in Dormont or South Hills, whatever the hell it is. I'm not even trying to fight this one. That's number 4! No I haven't and will not learn my lesson! I think I said the same exact thing after posting the last one, lol!
cb