Vancouver, WA / Portland, OR - Frame Shop?

Reply Subscribe

Thread Tools

Search this Thread

Aug 3, 2008, 05:37 AM

#16

IndoLancr84

Newbie

Join Date: Oct 2003

Location: Portland, Or

Posts: 4

Likes: 0

Received 0 Likes on 0 Posts

P.C.C. dont charge for labor and good work. atleast when i was there.

Reply Like

Aug 3, 2008, 11:58 AM

#17

metalmellinium

Newbie

iTrader: (5)

Join Date: Aug 2007

Location: Kirkland/camano island

Posts: 91

Likes: 0

Received 0 Likes on 0 Posts

I typed up a half *** estimate, to rpl the rail, rpl, core support, set up measure for 2.0, pull for 4.0, came out to be 2500 thats including parts. But thats not even close to what needs to be done to that car really. You should just turn that into a figure 8 car and buy a new one haha

Reply Like

Aug 4, 2008, 09:21 AM

#18

RallyDSM

Evolving Member

iTrader: (21)

Join Date: May 2007

Location: Yukon. Oklahoma

Posts: 333

Likes: 0

Received 1 Like on 1 Post

Quote:

Originally Posted by hanahawaiian

oh lord... u might need new \ front core radiator core support sheet metal..

Might?

LOL!!!

I've been through this before... Built my current Rally car from far WORSE than what you have there. It's not impossible, but time and money consuming.

It really depends on how "new" you want it to be. Fairly straight and fish plate reinforced or new rail and ready for the resale market new?

Either way, it's never going to be the same, but it will always be and EVO.

If the expense gets overwhelming and get bummed... come on over and see my car. Entire front end was replaced, one piece at a time. It will encourage you that there IS hope.

And then again, if you loose all hope... you will then know where you can leave the keys

<--- JOKE!!!

I'm in vancouver, wa, about 10 minutes south of you. We could do the work to, but you'll have to wait a bit as we just moved the shop.... I don't know when we could get to it, so I'm reluctant to offer to much help at this point.

Anyway, give me a shout and we'll see what we can do.

Scott

Reply Like

Aug 4, 2008, 09:34 AM

#19

ETS Michael

Former Sponsor

Thread Starter

iTrader: (91)

Join Date: Mar 2007

Location: Vancouver, WA

Posts: 8,685

Likes: 41

Received 54 Likes on 43 Posts

Scott,

Hahah.. That I don't really want it to be in resale value, just allow everything to bolt back up =) I figure i could purchase the front core support and have the driver side straightend up a bit. The car is actually in vancouver, wa where i live.