Up for grabs are my set of DSS lv5 rear axles. Just the axles, no hubs/bearings included.

Contacted DSS and the rear hubs don't need to be changed to fit these, spline counts are the same as factory, the count they refer to on their website is the number of splines inside the axle to the center of the C/V joint.

Ready to bolt up and go!

Build is on hold so I figured I'd turn these guys into capital for chistmas presents I don't think my little girls would appreciate these anyhow.

SOLD

 

Bumping it up! Feel free to throw offers out.

 

PM's replied

 

bumping it up

 

Bumping for a price drop!

 

You do not need the hubs/bearings to make these work? How many launches/miles on them?

 

Sent you a PM AngryEvo8

 

was wondering the same....

 

Never tried fitting them on the car yet, bought them this way myself.

Contacted DSS and you can get the flanges seperately still.

 

Contacted DSS again to verify the answers to some of the questions I've been getting, learned somthing new. I've asked them about the hubs before and apparently the term "hub" means different things to different people.

The spline count diference is on the inner hub of the C/V joints. They didn't say anything about the ends that go though the wheel hub being diffrent.

 

Updated first post with new info.

 

Bump

 

How is this possible? DSS states a different wheel bearing and hub to run a level 5???