im in trussville/pinson area anyone up for a photoshoot one da . im no pro but i can take pretty good pic, open to a lil drive,, just throwing it out there

 

trans and clutch are in the car. its not put together yet, but the hard **** is done. Then I started working on the house. I'm not sure which was worse... lugging 2x4x8's up a small hole and going the length of the house screwing them down (gangway to get from one end to the other to work on stuff. low roof line makes life really fun).

Did find a vent that was leaking at the main duct, so I sealed that up there while I was suffering. gotta run about 4 more over the master bedroom, but I'll get to that tomorrow. I need to invest in some knee pads, my ****in knees and shins are killing me.

 

damn, everyone in 'bama must be dead.

finished the transmission junk, started pulling the cams out to do stem seals (booo). then its buildacooler time :-D

 

Upgraded our brake lines, and fluid this past weekend. Ferodo pads, goodridge lines, and Motul fluids...love them. what everybody else up to?

 

I'll be gouging my eyes out with a......errr I'll be doing valve stem seals on-car this evening.

 

pullin the motor out sometime this week. Was going to have it done last weekend but decided to bust my knuckle on the oil pickup and slice it wide open.

 

ouch...that sucks...

 

nice. automotive scars on the hands for the win. I have several I've collected over the years.

 

So, does anybody have there car together enough to hit MMP soon?

 

I should before too long.

 

I had a Hurricane come thru my Shop last week. FInally got the 2 projects out the dorr and now am back on the Intake manifold and the stock replacement turbo manifold. I also have 3 other projects ongoing. Lots to do, which is good. We are still on planning to organize the Cheaha Cruise here ina few weeks. I should be able to get caught up here tomorrow ..maybe..lol..

 

whats up guys just picked up my crack rock on wheels last week anyone local in Birmingham?

 

Do u work at jim burke? I'm local by the way

 

pic or ban...

 

no sir i work in Pinson at III phase i rebuild 15000 volt circuit breakers