And still nobody replies, lol!

 

I put my VC-25D inside the car and put a T in the line to my boost gauge.

 

we already figured out this!!!

 

Hey alicea8541, which nozzle are you using on your setup?

 

M8

 

I <3 mine

 

mine is working good now... just had to dial in the trip point... but for some reason the green led isnt working now... i have to go check the wiring.

 

Mine is going in soon. VC-100 controller. No maf.

 

anyone have any new pictures of there installs???

 

I posted some somewhere on here.

If you want links send me a pm.

 

for those of you who mounted your pump in the trunk...what wire did you tap into for the + 12v source?

 

i pulled off my back seat and all the plastic kick pannels on drivers side and ran my electrical wires following the group of wires already going to the main fuse box under the steering wheel...

 

Excuse my ignorance but i didnt get any instructions with the fail safe...where do the wires go to on the failsafe?

I understand the Wires on the controller go like this:

Black: ground
Red: 12v power source
Yellow:white wire with red stripe on MAF
Green:red wire coming from pump

What about the failsafe??

 

black - ground
red - +12v power
yellow - flow gauge ( if you bought one)
Green - to the boost by pass

 

Thank you sir!!