Ok just very briefly which part do you want to see dyno figures on and I will get them for you and post on here or I will send the recorded sheet to your email address just to show that the numbers are out there...

and you are quiet right money is too hard to earn to go investing in something that is not going to deliver what you are wanting -

just keep in mind that the dyno results that I give you is for a part not nessicarily for a whole system so and so parts to work at there maximum need other parts for eg, the large diameter headers when they were dynoed we did not get a very good number simply because we ran with the factory stock intake so now the headers became restricted due to the lack of intake flow but when I raced using just the header and full exhaust my times dropped from 15.9 second down to 15.5 second, I think from memory the dyno result was only 8hp and 3 nm of torque

http://www.rpw.com.au/shop/index.php...d=96&Itemid=40

this link will take you directly to the RPW site were all the info and dyno sheets are there are also a couple of gentlemen on this site that have installed the RPW header on there cars and are very happy with the results one is a auto and the other is a manual - have a chat with them and I am sure that they will confirm that they are happy with the results and fitment of the headers

 

You're not being a party pooper, you're just not searching. This info that you're complaining about not being here, IS here. You just have to perform some searches. Previously you asked "If I'm wrong, then please someone let me know," so I did, simple as that. I'm sure both RPW and RRM are both well aware that most of us would want proof these mods are doing anything for us. Usually, they put their numbers for their products in their own threads that they created. As mentioned before this thread is just one customers experience. No offense meant at all. It just seemed like you were being a little hard on something without first having all the info. Cheers