Ic bolt wont line up
#1
Newbie
Thread Starter
iTrader: (2)
Join Date: Feb 2012
Location: New York
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Ic bolt wont line up
I just installed my X intercooler, i noticed that i couldn't line up one of the two bolts on the bolts on the bottom of the ic, i got the right one but the left just wouldnt line up, so i just left it with one bolt and the hangers, is this okay? an suggestions?
#2
Evolving Member
iTrader: (1)
Join Date: Aug 2012
Location: Earth
Posts: 111
Likes: 0
Received 0 Likes
on
0 Posts
The X IC should bolt up no problem. I had no problems with mine, only a pain withthe LICP. But I have also read other threads of people not bolting it up at all. Leaving the hangers and IC piping to hold it and they had no problems that way. If it was me, i would make a bracket or something to bolt the last bolt. But then again, im paranoid. Lol
#4
Hangars and one bolt will be fine if you don't want to get back into taking off the bumper... When I did mine I had to put one bolt in only a few threads and than the other in a couple threads than tighten them down. Also yes, the LICP was a chore!
Thread
Thread Starter
Forum
Replies
Last Post
qubit
Evo X Engine / Turbo / Drivetrain
8
Nov 18, 2012 11:50 AM
LEVIII
Evo Engine / Turbo / Drivetrain
11
Apr 13, 2005 11:44 AM
JVlancer
Lancer Aftermarket Forced Induction Tech
23
Dec 23, 2003 06:28 PM