I can't get my EVO to connect. I have a IX, but I was under the impression that I could read my ECU, just not change it.

Here is what it says:

[08:11:49.953] Version 1.27.658
[08:11:49.953] 9 memory models read.
[08:11:50.343] 66 ROM metadata models read.
[08:11:50.343] checksum module "subarudbw" loaded.
[08:11:50.343] flashing tool "wrx02" loaded.
[08:11:50.343] flashing tool "wrx04" loaded.
[08:11:50.343] flashing tool "sti04" loaded.
[08:11:50.343] flashing tool "sti05" loaded.
[08:11:50.343] flashing tool "evo" loaded.
[08:12:07.296] This vehicle interface does not support needed features.
[08:12:07.296] unable to connect to vehicle interface.
[08:12:46.843] This vehicle interface does not support needed features.
[08:12:46.843] unable to connect to vehicle interface.
[08:12:58.859] This vehicle interface does not support needed features.
[08:12:58.859] unable to connect to vehicle interface.

Girlie

 

they are still working on the evo 9

 

Oh, I thought I could still read it, just not flash? Someone below with a 9 has pulled his?

Girlie

 

It says this vehicle interface does not support needed features, which is not what I got on my VIII when I was unable to connect due to a port issue, so maybe it's just not compatible.

However, just to be sure, check your Options>Port to make sure it's set to use the 1.3 OpenPort.

 

The only thing that comes up under Options-Port is COM3

 

Make sure you plug your cable in before you start the EcuFlash software or else it wont recognize it. Try resetting also, especially if you just installed the drivers.

 

You will get that message when the cable is not installed properly. Try reinstalling the drivers.

 

Got it to work.

Thanks all!

Girlie