sick, you should log icv steps before and after the update.

 

That makes sense... so even if I change the axis on my ISCV lookup table, the "desired" tables will still have the wrong data. Am I guessing that nobody is really adjusting or looking at the "desired" tables and just changing the lookup table?

 

I dont think anyone wants to invest a ton of time into it. If we can get it to work/fix the throttle hang with little investment i think it will make everyone happy.

 

Here is my current setting. It has cold start and eliminated or nearly eliminated all the throttle hang.



That pic is horrible. anyways, its 58s all the way down the last row.

 

I tried this one, didnt give enough cold start ie. went to idle too soon. Try out my settings i posted above and let me know how it works for you.

 

^^^ Yours looks good. I would even go to 51.

 

65's were fine, 58's are better, 51 I didnt notice any difference.

 

I did 50, from the 51 row down and after cold start, the idle was too low. I also tried 0 from the 51 rowdown, but that didnt work.

I think we can taper it back down hitting 0 by the last row in the last colum, but thats just a though.

 

heres my example of taping it to 0. Im gonna try it out later.

sorry pic is sh!tty

 

I also have the same throttle hang problem this is my idle table. What should I change? [IMG][/IMG]

 

Make it look like the pic in my post, #229. With those setting you should have no throttle hang and still have cold start.

 

My tables looks completely different than yours. on top yours says temps while mine is throttle possition. And your rpm is lower. How do I go about changing mine?

 

https://www.evolutionm.net/forums/sh...&postcount=206

 

Did you tried that?

 

it doesnt matter. In my pic those are the correct things. post below yours shows the post that talk about the correct scaling.

Regardless you an still change teh table and it will work.