no, I made a mistake in my post. I am thinking the pin is correct but the rpm reading is now mimicking the afr not rpm.

 

any ideas, I notice all my logging methods have the rpm now mimicking afr.

ie logworks, evoscan and even the gps evoscan, which I have not altered.

it was an old xml combined with new innovations

 

I am having the same problem. But, I did have it working for a few minutes. Once I shut off the car and turned it back on, it would not work again.....it reads 20 AFR constantly (as if the analog wire is putting out a constant 5 volts)

 

The formula i originally entered was wrong so after i fixed that it read fine. But it still reads a little different compared to my gauge.

 

Whats the formula that you are using now?

 

Damn, I'm having a noob moment here.. which is mut12? is that mut1x (and then over to column 2? the orig. value there is 0x88DD). I changed that and get a steady... 7.35. This is with the v7t5 evo8 tephra rom.

 

Correct, and 0x88DD is the correct factory value for that entry.

 

crap, it didn't work. I'll default the lc-1 and try again this afternoon. Thanks for the verification

 

uego formula , can anyone on evoscan and aem uego help me out on how to ??
i got all the hardware need help on how to

 

Anyone have this patch for the new standard 8 ROM 96530006 or the code to simulate the NB O2?

 

the sim is including in my tephramods...

just log the rear02 like normal to get wbaf

 

Tephra, cool thanks, didn't realize you had picked up the LC1 WB logging. Have you incorporated using the WBAF to simulate the Front O2 NB sensor?

 

nope

 

Hmmm....any plans or is that strictly a MrFred deal?

 

alright guys im having trouble with the ecuflash part. what is mut address. im using 94170015


<table name="Rear O2 (ADC 0A) RAM variable" category="Rear_02" address="?????" type="1D" level="1" scaling="Hex16"/>

PLEAE help . i have the pin installed and tephra's o2 simulator on. i tired to log it but its at a steady 13.xxAFR through the ecu.