Hey guys I had a mess up the other day...was helping a buddy Flash his car, but I hit the WRITE button insted of the READ butting on ECU Flash and wrote a tune into his car....I never got the stock tune out so I need to disable the immobilizer. This is how Razor said to do it...Where do I put these setting and does it matter on the ROM ID?

 

Put this:

<table name="(periphery 0)" category="Misc" address="faa" type="1D" level="1" scaling="Hex16"/>

in your rom.xml, so if it is 88590015, then put it in your 88590015.xml

Save it, open ecuflash,

look for the map that says "(periphery 0)" under Misc, click in it (should say 56DA) then click "edit" and then "set data", little window pops up.

Then type 0x56D2 in that window and hit enter.

done

 

Bryan = ridiculous

 

update his car is alive

 

For future reference:

http://evoecu.logic.net/wiki/Periphery_Configuration

and

http://evoecu.logic.net/wiki/Immobilizer_Disabling

Updates to those pages, particularly the first, would be very welcome (I'm looking in Bryan and mrfred's direction here ). It'd be nice to get a more complete description of each bit on the page rather than just the short EcuFlash summary.

 

BIG Thanks to RoadSpike and Razor! Its alive...man...I feel like a jack ***.

 

what if it doesnt say 56DA? v.15

 

If your version of EcuFlash is 1.35 or newer, see the second link I posted above.

 

I was wondering if that was it, but didn't want to change anything without being sure.

Thanks!!