Notices
Evo Engine / Turbo / Drivetrain Everything from engine management to the best clutch and flywheel.

problem after clutch install HELP

Thread Tools
 
Search this Thread
 
Old Nov 29, 2008 | 09:27 PM
  #1  
Jersey Dino's Avatar
Thread Starter
Evolved Member
iTrader: (4)
 
Joined: Apr 2006
Posts: 578
Likes: 3
From: North Jersey
problem after clutch install HELP

I put my exedy twin in. everything appeared to be fine. It started and drove. I had a little sputter so I thought maybe a charge pipe was loose or acd needed to be re bled. came back try to try and take a quick test drive and its stalling and sometimes not starting. it did give me a vehicle speed sensor error before. I am going to take it back out and take a look. any suggestions? also how much noise/chatter do these twins make when the clutch is pushed in? sounded loud but was also barely keeping an idle. any help would be greatly appreciated. thanks in advanced
Reply
Old Nov 29, 2008 | 10:03 PM
  #2  
Jersey Dino's Avatar
Thread Starter
Evolved Member
iTrader: (4)
 
Joined: Apr 2006
Posts: 578
Likes: 3
From: North Jersey
update. removed the vehicle sensor and reinstalled it. no signs of damage. no cel after a few minutes of running. BUT now the car idles a few minutes comes down and just drops really really low everything shakes and it stalls out. any ideas what the hell i could have done along the way to installing this thing? btw NO CEL
Reply
Old Nov 29, 2008 | 10:05 PM
  #3  
PeteyTurbo's Avatar
Evolved Member
20 Year Member
iTrader: (9)
 
Joined: May 2004
Posts: 1,581
Likes: 10
From: Philadelphia
hi
Reply
Old Nov 29, 2008 | 10:15 PM
  #4  
huevosrancheros's Avatar
Evolved Member
iTrader: (14)
 
Joined: Sep 2007
Posts: 1,095
Likes: 1
From: The Stream Of Carol , IL
bump
Reply
Old Nov 29, 2008 | 10:19 PM
  #5  
PeteyTurbo's Avatar
Evolved Member
20 Year Member
iTrader: (9)
 
Joined: May 2004
Posts: 1,581
Likes: 10
From: Philadelphia
is there gas in the car?
Reply
Old Nov 29, 2008 | 10:20 PM
  #6  
red evo8's Avatar
Evolved Member
15 Year Member
iTrader: (58)
 
Joined: Jan 2006
Posts: 1,951
Likes: 1
From: Norman, OK
check vacuum lines if you forgot to reconnect any?
Reply
Old Nov 29, 2008 | 10:38 PM
  #7  
Duh Panda's Avatar
Evolving Member
iTrader: (5)
 
Joined: Jun 2007
Posts: 423
Likes: 2
From: El Paso, Tx
maybe a vacum line.. did you reconnect ALL the sensor?!
Reply
Old Nov 29, 2008 | 11:00 PM
  #8  
Jersey Dino's Avatar
Thread Starter
Evolved Member
iTrader: (4)
 
Joined: Apr 2006
Posts: 578
Likes: 3
From: North Jersey
all sensors appear to be connected. nothing really comes apart to drop the trans. its just the speed sensor and back up light up there...
Reply
Old Nov 29, 2008 | 11:08 PM
  #9  
Jersey Dino's Avatar
Thread Starter
Evolved Member
iTrader: (4)
 
Joined: Apr 2006
Posts: 578
Likes: 3
From: North Jersey
update for everyone who was so helpful here. apparently these things need gasoline to run...put 5 gallons in and what do you know. the b!tch runs...wow I feel retarded. at least i got the install done with out any real hicups...
Reply
Old Nov 29, 2008 | 11:10 PM
  #10  
Jersey Dino's Avatar
Thread Starter
Evolved Member
iTrader: (4)
 
Joined: Apr 2006
Posts: 578
Likes: 3
From: North Jersey
I havnt driven it in a week and now that I jogged my memory I remember needing fuel badly and pooched it home with the intention of doing the clutch job and then getting it. Why? I dont know probably lazy after a 12 hour shift...
Reply
Old Nov 29, 2008 | 11:10 PM
  #11  
Duh Panda's Avatar
Evolving Member
iTrader: (5)
 
Joined: Jun 2007
Posts: 423
Likes: 2
From: El Paso, Tx
Originally Posted by Jersey Dino
update for everyone who was so helpful here. apparently these things need gasoline to run...put 5 gallons in and what do you know. the b!tch runs...wow I feel retarded. at least i got the install done with out any real hicups...



wow man! jus WOW!!!

good job.. not everyone can do a clutch swap on these *****es!
drink up man!
Reply
Old Nov 29, 2008 | 11:17 PM
  #12  
Jersey Dino's Avatar
Thread Starter
Evolved Member
iTrader: (4)
 
Joined: Apr 2006
Posts: 578
Likes: 3
From: North Jersey
wow is right. and as my brother was helping me bleed the ACD he said "dude you have like no gas" i was like whatever I will get it later. what messed me up was that the car started and ran and even drove a little bit. turned around parked it home and then it was intermitted. should have heard me filling it up from a gas can. sounded just like taking a **** after a hard night of drinking lol
Reply
Old Nov 29, 2008 | 11:23 PM
  #13  
DIDYSIS's Avatar
Evolving Member
iTrader: (18)
 
Joined: Sep 2007
Posts: 467
Likes: 0
From: West Jordan, Utah
LOL, wish everything was that easy to fix :-)
Reply
Old Nov 30, 2008 | 12:01 AM
  #14  
justa4banger's Avatar
Evolved Member
iTrader: (14)
 
Joined: Mar 2008
Posts: 1,340
Likes: 0
From: underground
Originally Posted by DIDYSIS
LOL, wish everything was that easy to fix :-)
me too
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
vics(evo8)
Evo X Engine / Turbo / Drivetrain
13
Nov 16, 2011 01:57 PM
blackbichGSX
Evo Engine / Turbo / Drivetrain
11
Aug 7, 2007 04:50 PM
Johnboy1065
Evo Engine / Turbo / Drivetrain
11
Apr 3, 2007 07:48 PM
woodc
Evo Engine / Turbo / Drivetrain
4
Jun 16, 2005 06:46 PM
ku7484
Evo Engine / Turbo / Drivetrain
7
Sep 9, 2004 03:18 PM




All times are GMT -7. The time now is 07:56 AM.