ch53avitech

iTrader: (37)

I have a spare IAC that I took off my car due to idling issues (the IAC wasn't the problem). Does anyone have a diagram for the IAC plug so I can test it? I want to make sure it's a good IAC valve before I sell it. I guess I just need to know what pins I need to hook a power and a ground to.

Thanks

ch53avitech

iTrader: (37)

Ttmft

ch53avitech

iTrader: (37)

No one knows?

SilverShadow03

iTrader: (19)

I was told if you disconnect it from the TB and leave the wires/harness on it and put the key to the on position (maybe crank it over??) you should hear/see the shaft move/turn if it is still good.

Give that a shot...

**confirm this before attempting...**

ch53avitech

iTrader: (37)

Thank you. I was leaning more towards just somehow giving it power via 12v battery. The valve has 6 pins but as far as I know it should only need power and a ground to actuate.

I'm aware of the suggestion you mentioned though. Thanks for the input.

ch53avitech

iTrader: (37)

More help please.

Evoryder

iTrader: (55)

hope this helps

ch53avitech

iTrader: (37)

Thank you Evoryder, I'll try this out tomorrow tomorrow when there's more light and after my hangover wears off.

Thanks again.

Evoryder

iTrader: (55)

^ Any luck?

jbenosa

iTrader: (7)

yes, any luck? i think my IAC is bad ('03 Evo8) and may need to replace mine.

Evotech8

iTrader: (4)

^ test it first...

I bought a new one but it didn't solve my idle stumble problem. Wasted $300-