Take the head back off and check it out.

 

already did last night. found nothing suspicious. i think im gonna get a new gasket and try it again.

 

are you sure the gasket was on correctly?

 

yes. it can only go on one way. i thought maybe i was stupid too so i tried it all ways possible and only one way lines up. so yes its on correct.

 

And you torqued it down in the correct sequence incrementally?

 

yes sure did 20 50 80 worked my way inside out

 

good luck

 

let us know how it goes second time around

 

Lets think about this...You said your oem engine blew? So did you get a used engine and put your old head on it or got a used long block with a head? Coolant can only get into the CC a few ways. Cracked bores( which I doubt it is as you say its all cyl) Cracked head again may not effect all cyl. Warpped head or block. This is most likely your problem. Check both surfaces with a straight edge. A real straight edge not a old metal ruler.

 

A you reusing the old head studs or new?

 

its the old block with a used head. and yes i bought arp head studs.. im banking that there was something wrong with my head gasket. im gonna bring my head to a shop to make sure it is straight.