update

kevin d from evolution dynamics re-wired the gauges using the advice given to me by the tech support guy at aem. problem still exists. sucks. i dont know what the deal is, i am disappointed because these are really nice looking gauges but are pointless if they dont work properly

 

Did you show those videos to AEM? There tech support is normally really good about everything they sell.

 

did u end up selling the gauges?

 

I tapped a meter wire in the drivers kick panel.... I think it was red/yellow stripe, its been a while though.

Once you get a power supply while cranking your problems will go away... but you do have to wait 1-2 seconds before cranking though. The gauges have to zero before you crank or you still have have accuracy issues. They suck, don't know why they are like that.

 

God damn necro bumps.

 

Ok thanks I'm installing them in the next week or so